Initial Controller Setup; Step 1 - Language Selection; Step 2 - Hydraulic Scheme Selection - ModvlvS ACC30 Handbuch

INITIAL CONTROLLER SETUP

Constant temperature controllers are equipped with an innovative solution, which allows
initial setup of the controller in only three steps.
When you connect the controller to the power supply for the first time, the software version
is shown. Next, the first step appears on the screen.

STEP 1 - LANGUAGE SELECTION

STEP 2 - HYDRAULIC SCHEME SELECTION

Selected hydraulic scheme can be later changed with service parameter
S1.1.
4 English
Using buttons and
language.
Press the button
After selecting the language, the controller requires
confirmation of the selection by pressing the
button .
If you accidentally selected the wrong language, go
back to reset the language by pressing button
Next, you select a hydraulic scheme for the control-
ler function. Move between schemes by means of
buttons and
Confirm the selected scheme by pressing the
button .
After you selected the scheme, the controller re-
quires confirmation of the selection by pressing the
button .
If you accidentally selected the wrong scheme, go
back to reset the scheme by pressing button
you select the required
to confirm the selected language.
.
.
.