Klarstein VAN DAMME 10028320 Bedienungsanleitung Seite 12

EN
12
OPERATION
Before first Use
• Wash the mixing cup with warm soapy water. Rinse and dry well. Clean the mixing
shaft with a damp cloth.
• Pour the ingredients into the mixing cup WARNING: Since the volume of mixture
increases when making milkshakes, do not overfill the mixing cup, the maximum fill
level is 450 ml as marked on the side of the cup by a line.
• For a totally smooth shake without any fruit pieces, we recommend blending the fruit
before ad- ding it to the milk shaker goblet.
Getting Started
1. Tilt back the head of the appliance and position the mixing cup. To do this, place
the mixing cup under the spindle, slide it upwards under the upper mixing cup
holder and click it into place on the lower mixing cup holder.
Note: The appliance will only operate when the supplied mixing cup is correctly
positioned. If you wish to use a different sized cup then attach the „switch by pass
clip" shown in the diagram.
2. Make sure that the on-off switch (I-0-II) is in the "0" position (off) before plugging
the appliance into the socket. Plug in the appliance.
3. Place the switch to "I". The appliance will begin to operate, After a few seconds,
you may switch to the high speed II (FAST).
4. When finished, switch the on-off (I-0-II) switch to "0" (OFF).
5. Unplug the appliance.
6. To remove the mixing cup, tilt the mixer head back and slide the mixing cup off the
spindle.
Handy Hints
• Always make sure that the appliance is in the "0" (OFF) position before plugging it
into the socket and before removing the mixing up after use.
• For best result add wet ingredients before dry ingredients.
• If ice is used, only use crushed ice, never use ice cubes.
• Only use the mixing cup provided with the appliance and only operate when the
mixing cup is correctly positioned.
• Soft ingredients work best in the appliance.
• Do not use hot ingredients.
• For the frothiest milkshake use well-chilled milk.