Connecting Power - Barracuda CloudGen WAN Kurzanleitung

3

Connecting Power

• First, plug in the power cord on the appliance. Attach it tightly on desktop
models, or verify correct PIN connector installation on industrial models.
• Plug in the power cord to a power outlet.
• Power on the Barracuda CloudGen WAN appliance and wait 3-5 minutes until it
fully boots.
CAUTION: To prevent damage, connect the DC plug to the
appliance before plugging the power adapter into the AC outlet.
4
Next Steps
• Subscribe to the Barracuda CloudGen WAN on Microsoft Azure Marketplace.
• Go to https://cloudgenwan.barracudanetworks.com/
Barracuda Cloud Control credentials to configure your appliance.
• The appliance automatically registers with the Zero Touch service and
continuously polls for a configuration update. If you have already configured
the appliance, it automatically receives and applies the configuration.
• In case you need to add the device to your account manually, use the linking
code and serial number. The sticker with the Zero Touch linking code and the
serial number is located on the back cover of this document.
and log in with your
Setup 5