Preventing Equipment From Falling Over - Pioneer PDK-LS01 Bedienungsanleitung

Preventing Equipment from Falling Over

After installing the stand, be sure to take special care to ensure that the equipment will not
fall over.
Secure the plasma television to both the rack and the wall surface.
Stabilizing on a rack etc.
Fix the plasma television using the screws (M5 x 15 mm) and falling prevention hardware as shown in
the diagram.
Fix the racks etc. using screws for sale on the market.
Note
To stabilize the equipment on a table,
use screws that have a nominal
diameter of 4 mm and that are at
least 20 mm long.
Min. 20 mm
Using a wall for stabilization
1. Attaching falling prevention bolt (hook) to the column.
2. Using strong cord to firmly stabilize it appropriately and firmly to a wall, pillar, or other
sturdy element.
Note
Use hook, cord, and fitting that are
available on the market.
Recommended hook:
Nominal diameter M8
Length 12 mm to 15 mm
12 mm to 15 mm
8
En
This illustration shows the case of a
50 inch model (side speaker)
This illustration shows the case of a
50 inch model (side speaker)
Falling prevention
hardware
Screws
(M5 x 15 mm)
1
Hook
2
Cord
Fitting
Published by Pioneer Corporation.
Copyright © 2007 Pioneer Corporation.
All rights reserved.