nemaxx NTP16 Originalbetriebsanleitung Seite 9

b. Low temperature alarm at cooling mode (LO)
PV ≤ SV - 3°
PV displays LO and blinks, then triggers the alarm.
Note: the alarm will be clear only when the value of temperature has been changed.
AUTOMATIC MODE SETTING:
● Press the button
● With the button
● With the button
● Press the button
There are 3 different time windows (6 daily sections)
5+2 (working day Mon. – Fri.) + (weekend Sat. – Sun.)
6+1 (working day Mon. – Sat. ) + (weekend Sun.)
7 (working day Mon – Sun )
In the table are the default settings for the time segment. The value for weekday and weekend defaults to the
same, it can be changed all the value anytime as necessary for a different time segment.
Note: the number of the time segment will be shown up on PV bar.
Nr. Time
1 06:00 – 07:59
2 08:00 – 10:59
3
11:00 – 12:59
4
13:00 – 16:59
5 17:00 – 21:59
6 22:00 – 05:59
Error code Reason
E1 1st NTC sensor problem
HI 1. Too high temperature
2. NTC problem
LO 1. Too low temperature
2. NTC problem
for around 3 seconds.
to to select the hour, minute, and the temperature.
and to change the value.
to save the setting.
Temperature
20°C
20°C
20°C
20°C
20°C
20°C
ERROR CODE AND TROUBLE SHOOTING
EN
Circumstances
Sunrise
Outside
Lunch time at home
Outside
Evening at home
Sleep
Solution
1. Check the NTC sensor if well connected
2. Change the NTC sensor
Check the NTC senor if put the right place.
Check the NTC senor if put the right place.
9
KEN001THEFUL
v1a • 09.12.2020