CARAVITA BBK Bedienungsanleitung Seite 3

when concrete has completely set, the umbrella can be set up.
Remove the protection bag before installing if you do not have a push-rod which
enables you to remove the protection bag from a set up umbrella.
Install the supplied cover cap and fi nial at the top of the umbrella.
before setting up the umbrella, make sure the area is clear of people and objects underneath that could be harmed or
damaged and or could cause damage to the umbrella.
please be aware, that the umbrella is very tall, and thus hard to balance in an upright position. for this reason hold the
umbrella fi rmly when installing to reduce the risk of injury.
1) put one of the 5 fl ange screws (M10x25) into the central
hole. Let the screw protude about 10mm.
2) Carfully put the umbrella on the fl oor, with the lower
end pointing towards the ground sleeve.
3) Using the alignment guide on the base of the umbrella,
position on the central screw, and raise the umbrella with
both hands into an upright position.
CAUTION! - DO NOT LET GO OF THE UMBRELLA!
IT CAN STILL FALL OVER!
BBK - Page / Seite / Page / Página 3
SeTTInG uP THe umBrellA
4) hold the umbrella upright while a second person screws
it to the base with the 4 screws (M10x35) and the washers
provided. Do not tighten the screws yet.
5) adjust the orientation of the umbrella. Then tighten the
screws.
at times when the umbrella is not installed on the ground
sleeve, close the holes of the ground sleeve against dirt
with the provided fl ange screws (M10x25).
for safety-purposes, two people
should set up the umbrella.