Auto Shut-Off - Siemens TS47-Serie Gebrauchsanleitung

6. Ironing without steam
Begin ironing but without pressing the steam
release button.
7. Vertical steam

See the leaflet sides
This can be used to remove creases from
hanging clothes, curtains etc.
Warning!:
E
Never direct the steam jet at garments
that are being worn.
Never aim the steam at people or
animals.
1. Select "Jeans / • • •" programme to get the
optimal steam amount.
2. Hold the iron in an upright position 15 cm
away from the garment being steamed.
3. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing
the iron in a vertical position and pressing the
steam release button (14 or 15).
8. "silencePlus" button
Push the "silencePlus" button (6).
If the "silencePlus" setting is activated, you can
reduce the steaming noise for more than 50%
(*), and still achieve good results when ironing
most of your garments.
It is advisable to use the normal setting only for
thick and very wrinkled fabrics.
(*) In comparison to the maximum setting.

9. Auto shut-off

If during ironing, the steam release button
(14 or 15) on the iron handle is not pressed for a
certain length of time (8 minutes), the steam
station will automatically switch off.
The illuminated ring around the programme
selector (9) will flash when auto shut-off has
been activated. Three beeps will be heard at the
same time.
* Model dependent
To switch the steam station back on, press the
steam release button again.
10. Fabric protection
soleplate cover *
textileProtect

See the leaflet sides
The fabric-protection soleplate cover (18*) is
used for steam-ironing delicate garments at
maximum temperature without damaging them.
Use of the soleplate cover also does away with
the need for a cloth to prevent shine on dark
materials.
It is advisable to first iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place
the tip of the iron into the end of the soleplate
cover and pull the elastic strap over the lower
rear of the iron until it fits tightly. To release the
soleplate cover, pull the elastic strap and remove
the iron.
The fabric-protection soleplate cover may be
purchased from our customer service or from our
website.
Accessory code
(After-sales)
571510
11. calc'nClean Perfect
Automatic clean warning
The "Calc" automatic clean warning indicator
light (4) will flash indicating that boiler and iron
steam chamber must be rinsed.
Leave the appliance unplugged for more than
two hours, check carefully that the appliance is
cold and that the water tank (1) is empty.
Please proceed as follows:
Name of accessory
(online shop)
TZ20450
SIEM ENS
19