Special Programs - Siemens TS47-Serie Gebrauchsanleitung

If the garment to be ironed does not correspond
to any of the programs supplied, check the
temperature instructions shown on the care label
of the garment.
Temperature
●
●●
●●●
max
Tips:
• Sort your garments out based on their
cleaning symbol labels, always starting with
clothes that have to be ironed at the lowest
temperatures.
• For mixed fabrics, select the temperature
corresponding to the most delicate fabric.
• If you are not sure what the garment is made
of then begin ironing at a low temperature and
decide on the correct temperature by ironing a
small section not usually seen when worn
• At the beginning of each use, it is possible that
drops of water will be dispensed alongside
steam.
Therefore, it is advisable to try the iron on the
ironing board or a piece of cloth to start with.
• For better ironing results, iron the last strokes
without steam to dry the garment.

3. Special programs

3.1. "allTextile" programme

See the leaflet sides
This steam station has an "allTextile"
programme. If this programme is selected, an
appropriate combination of temperature and
steam is set, which is suitable for all fabrics that
can be ironed.
The "allTextile" programme prevents clothes
from being damaged due to an unsuitable
temperature being selected.
The "allTextile" programme does not apply to
fabrics that cannot be ironed. Please check the
garment care label for details or try ironing on a
part of the cloth not visible normally.
18
S I E ME NS
Programme
Synthetics
Wool
Cotton /Jeans
Linen
3.2. "antiShine" programme
antiShine

See the leaflet sides
This steam station has an "antiShine"
programme. If this programme is selected and
the steam release button (14 or 15) is regularly
pressed, the risk of shiny marks on the garment
due to the ironing is reduced.
3.3. "calc'nClean" programme
See section 11.
4. "pulseSteam" function

See the leaflet sides
This appliance has a special function for
tackling difficult creases.
When the steam release button is activated, the
steam generator will release three powerful
shots of steam so that the steam reaches even
deeper into the fabrics.
Briefly press the steam shot button (15) on the
top of the handle.
Remarks:
• It is possible to stop the shots of steam by
quickly pressing the steam button again.
• Some water drops may appear when you use
the "pulseSteam" function for the first time.
The water drops will disappear after you have
used the function for some time.
5. "intelligentSteam" function
This system has intelligentSteam control, which,
after releasing the steam release button
(14 or 15), provides a small amount of additional
steam.
The additional steam can always be stopped by
briefly pressing the steam release button once
again.
* Model dependent