Installation Instructions - Gastrodomus FT1L Handbuch Zur Installation, Bedienung Und Wartung

GENERAL INSTRUCTION
Read carefully the instructions given in this booklet. Before connecting the appliance make sure that the data
shown on the technical plate (Fig.1), corresponds with that of the mains power supply. Before carrying out
any operation, insulate the appliance from the mains power supply. The installation must he carried out by
professionally trained personnel in accordance with the instructions of the manufacturer and current
regulations.
The Manufacturer declines all responsability for:
 any damage resulting from ignoring the instructions for installation and use or from irregular use of
the appliance;
 any inaccuracies contained in this booklet due to copying or printing errors.
The Manufacturer reserves the right to make alterations thought useful to the product, without changing its
basic characteristincs.
THECNICAL DATA
Dimensions
mm
Power
W
Power supply
Dimensions hob
mm

INSTALLATION INSTRUCTIONS

1. The identifying and technical plate is fixed to the back of the appliance (Fig.1).
2. Remove the protective film from parts before using the appliance.
3. ELECTRICAL SAFETY RULES
Please observe these essential rules:
the mains voltage and that on the technical plate must be the same;

connection must be to a regulation earthed socket;

connection must be to an equipotential system.

4. POSITIONING: install the applince in well-ventilated surroundings. The applince may be installed against
walls provided that the letter feature adequate heat resistence; otherwise fit suitable insulating panels, or
ensure that there is a distance of at least 3 cm between the walls and appliance.
5. ELECTRICAL CONNECTIONS: must be carried out by trained personnel in accordance with electrical
norms. The power cable must be positioned so that no part of it reaches a temperature by 50°C. Before
installation make sure that the socket or switch used can be easily reached when the apliance is in place.
CAUTION: PRODUCER DECLINE ALL RFSPONSABILITY IF THESE SAFETY RULES ARE NOT
OBSERVED.
INSTRUCTION FOR USE
1. The appliance is intended for collective use and must be used by properly trained personnel.
2. Before switching on the machine for the first time, thoroughly clean off the industrial oils.Therefore prior to
use, operate the applince under no load for approximately 30 minutes at maximum temperature.
● Starting up
1. Put the plug into the power socket.
2. Turn the thermostat (A fig.2) until the temperature setting required is reached. The heating light (B fig.2)
will come on and will go off when the set temperature is reached. The light (C fig.2) on indicates that the
appliance is connected to the power supply.
3. Now the appliance is ready to be used.
FT1L - R
400 x 500 x 200h
3000
230V/1N/50-60Hz
395 x 400
4
FT2L - R - M
600 x 500 x 200h
6000
400V/3N/50-60Hz
595 x 400
FT3L - M
840 x 500 x 200h
9000
400V/3N/50-60Hz
835 x 400