After-Sales Service; Regulatory Information; Maintenance - S&P SILENT DUAL Serie Montageanleitung

In "OFF" position for 2 minutes.
1 2
In "ON" position for 15 minutes.
1 2
If no more movement has been detected once
the run-on time, set by the timer is passed and
the humidity level is below the start-up thresh-
old, the extractor stops automatically.
If the extractor detects a rise in humidity
(shower), the fan is boosted to high speed and
operates at this speed until the humidity level
drops below the start-up threshold level.
Continuous operation
To select this operation, place the
dip-switch "1" in the "OFF" position.
Operation is similar to intermittent operation
with the difference that the extractor does not
stop but runs continuously on trickle speed
(43% of the maximum speed).

MAINTENANCE

Fan equipment should be electrically isolated
and locked out before any work starts.
The extractor fan only requires periodical
cleaning using a cloth lightly impregnated with
a soft detergent.
PUTTING OUT OF SERVICE AND RECYCLING
EEC legislation and our considera-
tion of future generations mean that
we should always recycle materials
where possible; please do not forget
to deposit all packaging in the appropriate re-
cycling bins. If your device is also labeled with
this symbol, please take it to the nearest Waste
Management Plant at the end of its servicable
life.
Therefore, please deposit all waste material
and packaging in their corresponding recycling
containers and hand in the replaced units to
12
the nearest handler of this type of waste prod-
uct.
The fan is mainly made of steel, copper and
plastic. These components should be recycling
in the following categories:
- Steel and iron
- Plastics
- Electronic scrap
AFTER SALES SERVICE
We recommend you do not dismantle or re-
move any other parts than those mentioned, as
any tampering would automatically cancel the
guarantee. If you detect any fault, contact your
S&P dealer.

REGULATORY INFORMATION

Appliances in the SILENT DUAL range comply
with the following Directives:
• Low Voltage Directive 2014/35/EU
• Electromagnetic
2014/30/EU
• ROHS Directive 2011/65/EU
Compatibility Directive