Troubleshooting - Amica PGD4.1ZpZsAoGb Bedienungsanleitung

TROUBLESHOOTING

In the event of any fault:
● turn off the appliance
● disconnect the power supply
● have the appliance repaired
● based on the instructions given in the table below, some minor issues can be corrected
by the user. Please check the consecutive points in the table before you refer the repair
to customer service.
PROBLEM
1.The appliance does not
work
2.Burner does not ignite
3.Igniter does not work
4.The flame goes out when
igniting the burner
5.Hob cooking surface is
cracked.
6.When the problem is still
not remedied.
POSSIBLE CAUSE
- no power
- soiled flame outlet
- no power
- no power
- soiled (greasy) igniter
- burner knob pushed down
not long enough
- burner knob released too
soon
Danger! Immediately unplug the appliance or
switch off the main circuit breaker. Refer the repair
to the nearest service centre.
Immediately unplug the appliance or switch off the main circuit
breaker (fuse). Refer the repair to the nearest service centre.
Important!
You are responsible for operating the appliance correctly and
maintaining its good condition. If you call service as a result of
operating the appliance incorrectly you will be responsible for
the costs incurred even under warranty.
The manufacturer shall not be held liable for damage caused
by failure to follow this manual.
47
REMEDY
-check the fuse, replace if
blown
- close the gas shut-off valve,
close the burners valves,
ventilate the room, remove
the burner, clean and clear
out the flame outlets
- check the fuse, replace if
blown
- Open the gas supply valve
- clean the igniter
- hold down the knob until
you see a full flame around
the burner crown
- hold the knob down for
longer in a "large flame"
position