Error-Checklist - Schlick 940-43/7-1 S 147 Betriebsanleitung

Error-Checklist:

Problem
Spray pattern shows strings
and/or is uneven
"Sputtering" spray pattern
Liquid runs out, although
the needle is closed.
Liquid runs into the
control air distribution
Stand 15.10.2008
Reason

Twist body polluted

Liquid insert polluted

Liquid insert and/or air cap are/is
damaged (scratches, deformation
on the outlet-bores etc.)

Atomization air occurs the liquid
channel

Control air occurs the liquid
channel

Wrong assembly of the twist body

Liquid insert and/or needle are/is
gotten dirty

Sealing surface of the liquid insert
and/or of the needle is damaged

Sealing screw is not fitted tightly
and/or O-rings of the sealing
screw are damaged
Verfasser: Stefan Bätz
Elimination

Cleaning of the twist body

Cleaning of the liquid insert

Replace liquid insert and/or air cap

Check liquid insert for a tight fit

Check sealing screw for a tight fit;
check the O-Rings of the sealing screw
for damages and replace them, if
necessary

Correct assembly of the twist body
(see instructions on page 12)

Cleaning of the liquid insert and/or of
the needle

Replace liquid insert and/or needle

Check sealing screw for a tight fit
and/or replace O-rings of the sealing
screw
Seite 17 von 17