Inhaltsverzeichnis
Werbung
ATP
INSTRUCTIONS AND PARTS LIST FOR
ATP AIR IMPACT WRENCH ATP 1555
Read and understand "Safety Instructions for Air Tools" and these instructions before operating this tool.
OPERATING INSTRUCTIONS FOR ATP 1555
FORESEEN USE OF TOOL
Impact wrenches should only be used to install and remove threaded fasteners
AIR SUPPLY
The efficiency of the tool is dependent on the proper supply of clean dry air at 90 psig (6.2 bar). The use of a line filter, pressure
regulator, and lubricator will insure maximum output and life of tools. Before connecting tool, blow out the airline to remove water and
dirt which may have accumulated.
HOSE AND HOSE CONNECTIONS
Supply hose should not be less than 1/2" (13mm) I.D. Extension hoses should be at least 3/4" (19mm) I.D. Use couplings and fittings
with at least 1/2" (13mm) I.D. When using quick couplers, install a 6 ft (2m) leader hose between tool and quick couplers.
LUBRICATION
Use ATP BLUE MAGIC oil. An airline lubricator, set to deliver 1 to 2 drops per minute, is recommended. If a lubricator is not used, add
.06 oz. (1.8cc, 18 to 22 drops) of oil into the air inlet once daily.
GENERAL OPERATION
MAINTENANCE
Disassemble, clean, and inspect the impact mechanism every two months.
REVERSING SPINDLE ROTATION
The direction of the spindle rotation is controlled with the reversing lever located in the front of the motor housing, above the trigger.
Refer to illustration for spindle rotation vs. reverse lever position
SOCKET
Use only impact sockets in good shape.
Use deep impact socket impact rather than extension bars.
IF THE TOOL LOSES POWER, CHECK THE FOLLOWING:
• Air pressure
Ensure that there is an adequate supply of clean, dry air at
90 psig (6.2 bar).
• Sockets
Check for loose, worn, or cracked sockets.
• Hose Size
Ensure that the hoses, couplers and fittings meet the criteria specified in "HOSE AND HOSE CONNECTIONS" above.
• Dirt or Debris in Tool or Muffler
Clean tool or muffler as needed.
ATP
A DIVISION OF HY-TECH ENGINEERED SOLUTIONS
25 LEONBERG ROAD * CRANBERRY TOWNSHIP, PA 16066
CALL (724) 776-6800 OR TOLL FREE 1-800-245-1148
ATP 1555
.
REVERSE LEVER
REV
FWD
POSITIONS
www.hy-techinc.com
ATP
ATP
A DIVISION OF HY-TECH ENGINEERED SOLUTIONS
25 LEONBERG ROAD * CRANBERRY TOWNSHIP, PA 16066
CALL (724) 776-6800 OR TOLL FREE 1-800-245-1148
ATP 1555
www.hy-techinc.com
Werbung
Inhaltsverzeichnis
