Installation Recommendations - BWT RTM HF S-500 Montage- Und Bedienungsanleitung

1.

INSTALLATION RECOMMENDATIONS

Installation of the filter assembly below the water level of the pool is highly recommended. In the event that
the filter is installed above the pool water level, a check valve, accessible through a service hatch, must
be installed on the suction line.
Allow a surface area of 1200 mm x 1200 mm for the installation.
Position the control panel as close as possible to the multiport valve to facilitate manipulations.
To prevent vibrations, and any resonance effect, insert a sheet of soft rubber between the base of the
pump and the ground.
STANDARD INSTALLATION
A-B : Skimmers
C : Main drain
D : Vacuum point
E : Return fitting
F : Waste line
F
E
D
B C
A
13/32
CONSTRUCTION & RENOVATION 2020/10 - Indice de révision : H - Code : 26680