ICON IQHT103001 Gebrauchsanweisung Seite 6

INSTALLATION
Tools Needed:
* Pencil *Hammer
A wall mounting bracket is provide with the heater which has been specifically designed to allow
this product to be fitted to a ceiling before drilling the holders for the ceiling is solid and that there
are no hidden water pipes or electric wires. The heater must be installed no less than 19.7"from
side walls and no less than 2.4m off the floor.
ATTENTION! The appliance must be installed on the solid surfaces like concrete, wood or metal
etc.
Important: Ensure that the supply cables is well mounted and that it does not come into contact
with reflector of the heater or that does not trail into heated area, the supply cable can be fixed to
the metal mounting bracket behind heater with plastic zip ties.
1. This heater should be installed by a competent person, i.e. a qualified electrician.
2. Always disconnected the heater from the electricity supply and allow it to cool before
installation.
3. For ceiling mounting, the lowest part of the heater must be located at or above a minimum
height of 2.4m from ground level, so that the heater can not be touched when in operation.
4. For ceiling mounting, there must be a 2.4m distance from your appliance to the ground.
5. When installed to the ceiling, there must be a distance of 0.5m between corners and the
appliance.
6. The distance of your appliance from the living beings is to be min 1m.
7. The distance from the front side of the heater to materials such as wood, carton, cloth etc.,
must be min 1m.
8. When mounting to a ceiling, do not position the heater at an angle more than 90°and less than
45°.
9. The supply cable must be at the lower end of the heater if the heater is installed at an angle or
vertically.
*Level *Screw Driver *Power Drill and drill bits