Checking The Standard Accessories; Assembling The Stand; Assembly Procedure - Pioneer PDK-TS07 Bedienungsanleitung

Checking the Standard Accessories

Check to make sure that you have all the standard accessories before assembly and installation.
Base cover x 1
Screws (4 mm x 8 mm) x 4
Installation bolts
(M8 x 20 mm) x 2

Assembling the Stand

Assembly Procedure

1
Turn the base cover over so the underside is
facing up.
2
Insert the stand pipes into the base cover.
3
Tighten the screws (4 mm x 8 mm) to stabilize
the stand pipes.
Note
Assemble the stand with a soft sheet placed under the base
cover.
If a sheet is not laid before assembly, the front surface of the
base cover may be scratched.
8
En
Stand pipes
(left and right, interchangeable) x 2
1
Installation bolts
(M8 x 40 mm) x 2
2
Falling prevention
bolts x 2
Stand pipes
Base cover
Operating instructions
(this document) x 1
Hexagonal wrench x 1
(Opposite side 5 mm for M8 use)
Screws
(4 mm x 8 mm)
Screws
(4 mm x 8 mm)
Sheet