QEO FMR 800-M/C Bedienungsanleitung Seite 31

INSTALLATION BULLDOZER - MODE
Laser
· Place the bulldozer blade onto the benchmark, e.g. peg.
· Position the rotating laser at a suitable height and power-on.
· Connect the receiver to the machine mast and tighten screw clamps to secure.
· Power On the receiver, enter bulldozer mode and select the „fine" accuracy setting.
· Move the receiver up / down until the green LEDs are permanently illuminated.
If necessary, adjust the height of the receiver.
Alternative procedure:
If the height of the reference point to the laser plane is known, this height can be transferred as
well. Take the correct measurement between the on-level position of the receiver (green LEDs) and
the cutting edge of the blade.
· Turn the display of the receiver into the direction of the drivers cabin and tighten screw clamps to
secure the receiver firmly onto the mast.
· Select required accuracy (height indication and blade tilt).
· The LED's are now guiding the driver.
· If necessary, take a sample cut to check the blade height and tilt.
Receiver
Benchmark
EN
31