sylvac S_Dial WORK BASIC Bedienungsanleitung Seite 10

8. Connecting the instrument
E
The instrument can be connected to a peripheral via a Proximity (RS or USB), Power (RS or USB). See page 2 for
connecting the Power cable.
Measured values can be transmitted and the instrument driven using predefined commands (see chap. 9 for a list of the
main commands)
9. List of the main commands
Selection and configuration
CHA+ / CHA-
FCT0 ...9...A...F
MM / IN
PRE [+/-]xxx.xxx
STO1 / STO0
LCAL dd.mm.yy
NCAL dd.mm.yy
UNI1 / UNI0
OUT1 /OUT0
PRE ON / PRE OFF
PRE
SET
RES2 / RES3
Change measurement direction
Assign «favourite» function
Change measurement unit
Modify preset value
Activate / de-activate HOLD
Modify last calibration date
Modify next calibration date
Activate / de-activate change of units
Activate / de-activate contin. data transmission
Activate / de-activate Preset function
Recall Preset
Zero reset
Change of resolution
Interrogation
CHA? Measurement sense?
FCT? «favourite» function active?
UNI? Measurement unit active?
PRE? Preset value?
STO? Status of HOLD function?
LCAL? Date of last calibration?
NCAL? Date of next calibration?
? Current value (mode Tol, value followed by <=>)
SET? Main instrument parameters?
ID? Instrument identification code?
Maintenance functions
BAT? Battery status (BAT1 = OK, BAT0 = low battery)
OFF Switch-off (wake up using a button or RS)
RST Re-initialisation of the instrument
SBY Put instrument in stand-by (SIS)
VER? Version No. and date of firmware
10