Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Carton content
Measuring cup
Charger
1. Assembling
Take out the parts. (as shown on the right)
Connect the handle and aluminum tube 1.
Connect the pipe joint and aluminum tube 2.
Connect the foot, insert the installed tube into the hole of the foot.
2. Initial charge
Charge the machine for 3 - 5 hours the first time. The power should be
off during charging.
3. Water filling
Open the cap of the water tank, use the measuring cup to add water.
The maximum capacity of the water tank is 230ml.
Cleaner or essential oil can be used in the water tank but only when
diluted with water.
Please make sure to use clean water or otherwise the nozzle and water
pump could get clogged.
4. Cleaning cloth assembling
a.
Place the cleaning pads on the ground and lift the machine to put it on the cleaning pads, the
cleaning pads will automatically attach to the machine.
5. Start cleaning
a.
Pull back the handle, when doing this you will hear a sound. The power indicator lamp will
light up. When you place the handle upright, the power of the machine will be off.
b. The machine will automatically turn into "sleep mode" when not being operated for more
than 2 minutes, and the full battery light will twinkle. After a shutdown the machine can be
used normally.
6. Operating and spraying water
a.
Press the power button on the handle to make
the cleaning cloths do the cycling movement.
Press it again to stop.
b. Hold down the spray button to spray, it will stop
after releasing the button.
c.
Do not use while charging.
d. The longest time to spray is 5 seconds.
e.
Interval time on operating needs to be >15
seconds.
7. Battery
a.
3 battery lights will show to indicate how full the battery is. 3 lights
stand for 100%, 2 for 65% and 1 for 30%. If 3 lights are flashing the
battery is low.
Cleaning cloths
Scouring cloths
3 x
Product manual
Handle
Aluminum tube 1
Joint
Aluminum tube 2
Foot
Spray Button
Power Button
Charging port
Werbung
