Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Betriebsanleitung für Druckluftenthäuter PLE-10
4. Remove the finger guard (fig. 13).
Fig.
13
5. Release the blade fixing screw with a hexagonal
socket spanner 4 mm and remove (fig. 14).
Fig. 14
6. Release the upper blade suspension. Remove the
blade by turning downwards and pulling away (fig.
15).
Fig. 15
7. Fitting a new blade:
Push the blade holder forwards. Run the blade in
at an angle from below and turn upwards (fig. 15)
Important!
When inserting the blade in the blade
holder, y ou mus t fe el it notc h home .
Sustained o peration o f the mach ine
causes th e b earing o f th is p lastic
blade h older to wear o ut (bro ken) so
that th e b lade can th en be in serted
very easily without feeling resistance.
If th at is th e case, th e b lade h older
must b
e rep
otherwise th
damaged.
Important!
Whenever you ch ange the b lade
check the condition
holder.
Frequent ch ecks o f th e b lade h older
help to sa ve su bstantial spare p art
costs.
8. Thread the blade suspension onto the cylindrical
pin on the guard support and secure with the
blade
fixing
screw
Important: Check the alignment of the blade
suspension. It should be aligned as parallel as
possible with the guard support (fig. 16)
Fig. 16
9. Replace the blade guard on the guard support and
insert the blade (fig. 12).
10. Place the locking pins in position, i.e. push them
through the blade guard into the protective
backing (Fig. 17). The locking pins must notch
home in the central position.
GB
laced immed
iately,
e b
lade ma
y b
e
of
the blade
and
locking
ring.
18
Werbung
Inhaltsverzeichnis
