Woodstar wl 05 Originalanleitung Seite 16

Fig. 1.2
B
C
D
Fig. 1
1
2
3
10
16
•
•
•
Driver, Fig. 1.2
The driver (A) is used exclusively for work between both
centers.
A
Face plate, figure 1
The face plate is used with flat larger tools.
5
4 6
Change of the clamping tools
•
7
•
Tailstock, Fig. 1, 6
8
•
9
•
•
•
Close the casing and lock into place by turning the
screw of a revolution to the right.
When the cover is closed, read the adjusted speed from
the viewing-window.
When working with highly unbalanced workpieces, se-
lect a speed at least one level lower.
Loosen grub screw on the shaft of the clamping tool.
Retain spindle with mandrel, release the clamping tool
with the hexagonal spanner.
Once the eccentric clamp has been loosened, the tail-
stock can be moved over the entire length of the bed
and can be secured at any distance from the head-
stock.
To insert a workpiece between the centers, loosen the
binder, turn the sleeve approx. 20 mm outward and
clamp.
Slide the tailstock to the workpiece and place the tail-
stock center into the sunken point in the center of the
workpiece.
Screw out the tailstock sleeve until the tailstock center