Mechanischer Bausatz - Hetronic MEC-HL KOMPAKT Installationshandbuch

INSTALLATIONSHANDBUCH | MEC-HL C
When the neutral position is selected Active, the neutral position is automatically renewed every power
ON reset condition. In this case the receivers check that the actuators go back to the neutral position when
the control AK signal is in neutral. If the actuators remain out of neutral position while the control AK
signals are neutral, it will release the control of the actuators and will be in Manual status until a valid
neutral is verified for all enabled PWM outputs.
By activating Return to Neutral option, The Hetronic receiver will control the actuator in returning to
neutral position and release after a valid neutral is verified.
!
WARNUNG
Any changes to the setting files have to be saved and it is the full responsibility of the person performing
the changes that they are made in accordance to the worldwide norms of safety to avoid any dangerous
or uncontrolled action by the user.

Mechanischer Bausatz

Standard 4 Position Bracket
Abbildung 20.
22