ChiQ U50H7S Handbuch Seite 18

Select Satellite Re-scan.
Press [Right] to start scan.
Focus on Scan item and press [OK] or [RIGHT] to start scan.
Channel search from multiple satellites
1. In the "Channel Installation Mode" submenu, select the "Preferred Satellite"/ "General
Satellite" option underneath. It will turn back to previous menu level.
2. Press [DOWN] and [UP] on the remote control, select the "Channels" option and press
[OK] to display the "Channels" submenu.
3. Press [DOWN] and [UP] on the remote control, select the "Satellite Re-scan" option
and Press [OK].
The simple way to start scan for two satellites is using Tone Burst option.
a) Set one satellite enable and set it's "ToneBurst" to Tone Burst A
b) Set another satellite enable and set it's "ToneBurst" to Tone Burst B
c) Return to satellite list page and press Right to scan detail page.
d) Start Scan by pressing [OK] on Scan item
The scanning process will scan two satellites.
Another way to Scan 2 or more satellites is using DiSEqC Set.
Note: Single Cable and Jess Single Cable can be changed in the Setup Wizard and
"New Channels Available" after pressing [MENU] in the Live TV.
EN-17