Meister-Basic BEH 600 C Originalbetriebsanleitung Seite 49

5410050-Elektrohob-man 21.02.14 13:58 Seite 49
4 Power tool use and care
a Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be
controlled with the switch is
dangerous and must be repaired.
c Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of
starting the power tool accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained
users.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This
will ensure that the safety of the
power tool is maintained.
b To avoid hazards, damaged power
leads must be replaced by the
manufacturer or his customer service
representative.
Improper use of the product
All applications carried out with the
device that are not listed in the "Proper
use" chapter will be considered
improper use.
Uses for which the tool is not designed
may cause risks and injury. Do not use
accessories that are not intended
specifically for this electrical tool.
Just because you can affix an
accessory to your electrical tool, there is
no guarantee it is safe to use.
The permitted revolutions of the tool
insert must be at least as high as the
highest value specified on the electrical
tool. Accessories that turn faster than is
permitted may break and fly off.
There is a risk of injury. The user of the
device is liable for all property and
personal damages occurring as the
result of incorrect use.
If other components or non-original
components are used with the machine,
the manufacturer guarantee is voided.
49