EFBE-SCHOTT DKP 100.1 Gebrauchsanleitung Seite 6

Fax +32 2 359 95 50
UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)
This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp
plug is used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour
coded:
blue = neutral, brown = live, green or green & yellow = earth.
The blue wire must be connected to the terminal marked N or coloured in black.
The brown wire must be connected to the terminal marked L or coloured in red.
The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&
yellow).
USE
•
First check that your mains voltage corresponds to that stated on the appliance.
•
Select a suitable position close to an electric socket, on a dry and even surface.
•
Make sure the controls are in the lowest position (MIN facing upwards). This way, the
thermostatically regulated hotplates are not in operation at a normal room temperature.
Plug in.
•
The invisible protective coating must be removed before the first use. To do this, set the
controls to the maximum setting and leave the appliance (without saucepan) switched
on for approximately 10 minutes. Smoke will develop, make sure that the room is
ventilated. Switch off the cooking plates and allow to cool down completely. The cooking
plates are now ready for use.
•
Always use flat-bottomed saucepans, which make good contact with the cooking plates.
The saucepan bases should ideally be of the same size as the cooking plates. If the
bottom of the pots and pans is uneven or too small, you will waste energy.
•
Turn the control knob to the right to select the temperature. The cooking plates have a
range of temperatures.
•
Due to the cooking plates' construction, residual heat will remain after switching off. This
may be used to keep food warm for a short period.
•
After use, turn the temperature dial to "MIN" and unplug the appliance from the electrical
outlet.
CLEANING
•
Before cleaning, unplug and wait for the appliance to cool down.
•
Wipe with a moistened cloth.
•
Do not clean with any abrasive scouring pad or steel wool, as this will damage the finish.
•
Do not immerse in water or any other liquid.
PROTECTION OF THE ENVIRONMENT– DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it free of charge to a municipal collection point
performing waste recovery by means of reuse, recycling or use for other applications in
accordance with the directive.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
6
Assembly page 6/24
on the
SC DKP 100.1 - 090130