SVS Minicalll-12 Montageanleitung Seite 3

1 Mounting snap-in function (optional)
Place both locking levers (A) at the corresponding location, like illustrated below. Afterwards install both sliders (B), like illustrated
below. Now, the Minicall-12 will be fixed when putting it on. Only by using of the openeing mechanism (C) the Minicall-12 can be
removed.
2 Plane wall mounting
The minicall-12 can be mounted plane on the wall. Therefore, the plane lower part has to be mounted directly onto the wall using 4
screws. If you are using the snap-in function, insert spacers if the snap-in function sticks. The spacers are not included in the scope of
delivery.
3 Inclined wall mounting
Insert both covers (D) in the lower part of the holder (see below). Subsequently screw the lower part to the wall using 4 screws.
Finally screw the upper part an the lower part using another 4 screws. Be sure that the openings of the clamp holders point upwards.
A
B
D
- -
3
Assembly Instruction (D – GB)
C