Warranty - Mastrad F49414 Bedienungsanleitung

silicone washer, and the head's interior with the small bottle-brush that comes
with the whipper. Let all of the parts dry, and store them dismantled. Replace the
piston by going through the head's interior; screw the nut back on by pushing
down on the handle; then place the washer back inside the head. Mastrad does
not recommend using a dishwasher to clean this product.
11. Clean the piston carefully after each use (fig. A).
12. Do not use sharp objects to clean the whipper.
Safety:
- Maximum allowable pressure PS: 22 bar.
- Never open a pressurized cream whipper. It is imperative to empty any gas
remaining in the siphon completely before opening it. For a siphon no longer
containing a preparation, pull the trigger until the noise stops. For a siphon
still containing a preparation, allow the contents to stabilise in the interior for
several minutes, then cover the top with a thick cloth and hold the trigger until
there is no longer a noise.
- In case of malfunction (if the content being dispensed is not foamy):
• Verify the presence and/or correct installation of the silicone washer
• Verify the proper state of the silicone washer
• Verify that the whipper head is properly closed
- Return the whipper to the retailer if there is a blockage.
- Do not inhale the cartridge gas.
- Do not use more cartridges than recommended in the instructions leaflet.
- Do not touch a cartridge that has just been used: danger of burns.
- For safety reasons, do not lean on the whipper, as this could pierce the
cartridge.
- Never use a damaged, deformed siphon or a siphon that has been dropped
on the floor.
- Do not use a whipper that has any cracks or dents.
- Do not alter or modify your whipper's parts.
- Warning: only use Mastrad components.
Never combine components from another brand or manufacturer with
Mastrad Whipper components. We recommend that you use Mastrad
cartridges.
- Keep the whipper and cartridges out of reach of children.
- Do not dismantle parts beyond what is indicated in the instructions leaflet.
- If you use replacement parts, refer to the instructions leaflet.
- Description maintenance operations should only be completed by your
service center: removing a blockage in the whipper.

Warranty:

A defective cream whipper (faulty part or manufacturing fault) will
be repaired free of charge within 2 years of the date of purchase on
presentation of a receipt. This warranty does not cover damage caused by
incorrect use nor the use of non-Mastrad spare parts or any damage caused
by foresaid spare parts. To ensure the best use of your Mastrad cream
whipper, only use original Mastrad parts.
The warranty is void if the cream whipper is used incorrectly.
For reparations during the warranty period, always send the entire cream whipper:
tank, complete head and proof of purchase.
For spare parts, send your request directly to Mastrad SA or a retailer.
Read the instructions carefully before use.
Cream whipper componants:
a. Cartridge holder (F48782&F48882&F49082)
b. Plastic cover (F48783)
c. Tulip nozzle (F48780)
d. Star tip nozzle (F48880)
e. Straight nozzle
f. Screw thread valve (F48781)
g. Head
h. Seal (F48784)
i. Piston (F48785 & F49085)
j. Tank
If your whipper malfunctions:
Make sure that all of the whipper's gaskets are in the proper place: to
do this, press the trigger button to release all of the pressure. Once the
whipper has been emptied completely, unscrew the whipper and make
sure that the gaskets of the head (1) and the pistons (2) are not damaged
and are in the proper place. Once you have verified the above, you can use
your whipper again. If a crack is visible on a gasket, contact Mastrad's
customer service.
2
1