Pfannenberg Quadro LED-RGB-3G Sicherheitshinweise / Kurzanleitung Seite 4

en
Danger source
Fundamental safety infor-
mation disregarded
The following applies to all
work on voltage-carrying
equipment:
Only qualified personnel are
allowed to work on electric
devices!
Intended use
disregarded
Description of use
disregarded.
Type plate information
disregarded
Installation/
maintenance work
High brightness of the
flash function
Selection of operating
mode
External control input
Connection of the line
Note: Devices with DC voltage are equipped with reverse polarity protection. No function if the polarity of the
connections is reversed.
S1
Operating mode
1 2 3 4
OFF OFF OFF
Flashing light
OFF OFF ON Flashing light
OFF ON OFF Continuous light
Blinking light
OFF ON ON
ON OFF OFF Flashing light
Blinking light
ON OFF ON
Flashing light
ON ON OFF
ON ON ON Flashing light
Double Flash Mode (DFM3) see original operating
OFF OFF OFF
instructions
08/2020
Safety information / Quick guide Quadro LED-RGB-3G/3D
Danger Degree of risk / Possible consequences / Countermeasures
DANGER - Danger to life due to electric shock
Voltage-carrying devices and exposed connection cables may cause electric
shocks and serious accidents.
➢ Only trained and authorized electricians may work on electrical connec-
tions.
➢ Disconnect all supply lines from the mains before installation and secure
them against reconnection. Always ensure absence of voltage.
➢
The operating voltage must only be applied when the housing is firmly
closed
WARNING - Danger due to unauthorized use of the devices
Improper use may lead to serious accidents.
➢
Ensure that the connection cable is protected against pulling and twist-
ing during installation.
The devices are only intended for fixed installation.
DANGER - Hazard due to damage to the devices
Non-compliance with the information on the type plate can lead to
serious accidents.
➢ Always observe the information on the type plate when installing and ser-
vicing the devices.
➢
Observe the chemical resistance of the polycarbonate plastic.
CAUTION - Risk of injury due to sharp edges or heated components
➢ Wear gloves during any installation, assembly or service/maintenance
work.
➢
Perform wiring tasks at a distance from sharp edges, corners and internal
components.
CAUTION - Impairment of vision
➢
Avoid constant, direct glances into the activated lights to prevent impair-
ment of vision.
S1 Light intensity control
X1
*
.
Page 2/2
X2
Operating voltage
connection
DC:
AC:
Color assignment
S1
Color
4 5 6
OFF OFF
Red
OFF ON Blue
OFF
ON OFF Green
ON ON Yellow
*
Factory setting
*
086050005