For Operation - walser mantona Pro Makro II Bedienungsanleitung

2. For operation:

• Pull the levers for leg angle adjustment
• Adjust the legs, until the most suitable working angle is reached
• Open the clips on the tripod legs
• Extend the legs to their full length
• Tighten the quick-action locks
3. Near ground level work
• Loosen the lock on the centre column
• Remove the rubber cap from the underside of the centre column
• Slide the centre column out of its holder
• Turn the column around by 180 degree
• Fasten the centre column at a suitable working height
• Fasten the protective cap on the column
4. Removing the quick-release plate
• Press in the locking pin
• Loosen the locking lever for the quick-release plate
5. Locking the ball head
• Use of the locking lever on the ball head
(if the position does not permit locking)
• Pull the locking lever
• Turn it to a suitable position
• Let the lever click into place
• Tighten the ball head
Attention!
Back out the fastening screw only so far, that the ball
head is free to move, to prevent the inside of the head from being damaged.
8
6. Assembly of the ground adapter
• Remove the ground adapter from the underside
of the centre column
• Pull the long centre column out of the tripod spider
• Plug the ground adapter on the tripod spider
• Fasten the ball head on the ground adapter
7. Technical specifications
Pro Makro II tripod with ball head and ground adapter
Max. height
Min. height
Tripod connection
Length of centre column
Transport size
Weight
Max. load bearing capacity
Material
Scope of delivery:
mantona Pro Makro II tripod with
ballhead and ground adapter
ca. 151 cm
ca. 17 cm (0 cm with ground adapter)
3/8 Inch
ca. 31 cm
ca. 65 cm (with ball head)
ca. 2,5 kg (with ball head)
ca. 6 kg (with ball head)
Aluminum
Tripod with assembled
ground adapter
9