Directions For Use - Sun-Flex EASYDESK 610603 Montagehandbuch

Advanced function settings
Reset: Press "↑" and "↓" keys simultaneously for 10 seconds until you hear the beep.
The system is now in factory default mode.
Limited height setting: Press "↑" and "↓" key for 5 seconds until you hear the beep.
The limited height is set.
(minimum limited height <96 maximum limited height >97).
Lock and unlock: Press "↑" and "S" keys simultaneously for 5 seconds. When screen
shows "LOC", the system is locked. Press "↓" and "S" keys simultaneously for 5
seconds. When "LOC" is replaced by a number on the screen, the system is unlocked.
Press "S" key for 5
seconds until screen
shows "S-1". Press "↑"
or "↓" key to select

DIRECTIONS FOR USE

S-1
Switch metric and inch
S-2
Gyroscope anti-collision
sensitivity
S-3
Upward anti-collision
sensitivity
S-4
Downward anti-collision
sensitivity
S-5
Base height
S-6
"S" key for height
adjustment
7
S-
Operation duty recycle
S-8
Press "S" Key
Desk surface slope
sensitivity
0
Metric
Press "S" Key
1 Inch
0 Shut down
1 Minimum sensitivity
Press "S" Key
8
Maximum sensitivity
Shut down
0
1 Minimum sensitivity
Press "S" Key
8
Maximum sensitivity
0 Shut down
1
Minimum sensitivity
Press "S" Key
8
Maximum sensitivity
Use"↑" or "↓" to adjust the base height
Press "S" Key
Press and hold to lower/raise the desk.
0
Keep your hands clear of the desk!
Press "S" Key
Press to start, press again to stop.
1
0 Shuts down after each 2min/18
operating cycle. Control unit has
temperature sensor
Press "S" Key
1
Indicate start 2min/18min 1
operating cycle
0
Shut down
1 0.5°
2 1.0°
3 1.5°
4 2.0°
5 2.5°
6 3.0°
7 3.5°
8 4.0°
7 (9)
27/116
Press "S" key to go back, setting
complete
EN