Laserworld CS-500RGY Bedienungsanleitung Seite 7

Manual: CS-500RGY / CS-500RGY SE / CS-1000RGY / CS-1000RGY SE
8. Operation
1. Connect the power cable to the device and then to the mains
2. Press „ON" to switch the device on
3. Your device runs in auto mode:
Your device runs in music mode:
4.
5. Control the music-sensitivity by the trim pot at the rear side of the device. The LED is
flashing when the device is triggered.
6. Your device runs in DMX mode if '10' is switched off:
7. Connect a DMX controller to operate the laser.
8. Use the switches 1 - 9 to set the DMX address of the laser. Each switch represents a num-
ber. To define a number use the preceding number and multipy it by 2:
1
Switch
Number 1
The laser uses 12 DMX channels, so make sure that the next device uses an address that doesn't
overlap with this range.
2 3 4
2 4 8
5 6 7
16 32 64
8 9 10
128 256 Mode Switch
page 7 / 20