Werbung
EN
During Assembly
• Make sure the base is square by measuring the diagonals and level by using a spirit level.
• You may use silicone lubricant spray in order to help you slide the panels into the profiles.
• Do not spray the polycarbonate panels.
• Use a rubber mallet if necessary.
• All panels with the stamped words "THIS SIDE OUT" must be facing out to create
full UV protection. Remove plastic sticker as panels are locked in place.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
This icon indicates
that the installer should
be inside the product.
Attention
• During assembly use a soft surface below the parts to avoid scratches and damages.
Steps
Step 6: Determines the front side of the greenhouse.
Steps 10, 16, 19: The oval hole in the crossbars. 256 should always be assembled to the base of
the greenhouse.
Steps 12-13, 57: In order to insert profile #8378 in between two #7310 & 7311 profiles, please
apply silicone lubricant.
Door assembly (Steps 14, 57-65)
Door can be installed as a left hand door or right hand door to your decision. These instructions
show a right hand door assembly.
Step 14: Determines door direction door post 7311 is where door hinges will be located.
Steps 55-63: Door assembly should be done according to this decision.
This icon indicates that
the installer should be
outside the product.
Window assembly (Steps 39, 51-56)
Step 39: Decide on the window's location before assembly. Window can be installed in one of
the indicated options.
Steps 39+40: Once the window location is chosen, please turn part 7316 into the correct
position accordingly.
Step 56: In case the window is not closed properly, please go to Step 42, release the
screws, adjust the profile and tighten the screw.
* Please tighten all screws when completing assembly.
• Screws 411 and nuts 412 & 466 are used throughout the assembly process.
• Screws 411 are to be assembled from the outside and nuts 412 & 466 from the inside of
the greenhouse.
• If not specified otherwise, do not fasten screws and nuts (411, 412 & 466) more
than 2-3 turns only. Do not tighten them until completion of the panels' assembly.
These 2 icons indicate if screws' tightening is required or not.
• However, in some steps, temporary tightening of a few screws may be needed to
prevent a profile from falling.
Note: Firmly connect the product to a level surface immediately after completion of
the assembly.
Anchoring this product to the ground is essential to its stability and rigidity. It is
required to complete this stage in order for your warranty to be valid.
412
&
466
Werbung
