Product Overview - Pro-Elec PELL0203 Anleitung

PRODUCT OVERVIEW

3
2
1
ASSEMBLY INSTRUCTIONS
• The heater is packaged with the feet unattached. You must attach them before
operating the heater.
1. Place the radiator body upside-down on a scratch-free location, make sure it is
stable and will not fall.
2. Slot the rear foot onto the bottom of the
rearmost fin
3. Push the front foot into the slot at the base of
the front panel.
4. Check that the heater stands upright and is
stable before applying power.
WARNING: Do not operate without feet attached.
Only operate the heater in an upright position
(feet on the bottom, handle on the top), any
other position could create a hazardous
situation.
INSTRUCTIONS FOR USE
• Before using the heater, make sure that it is on a flat and stable surface. Damage
may occur if it is placed on an incline or uneven surface.
• Set all the controls to OFF position and insert the plug into a mains socket
• Rotate the thermostat knob clockwise to MAX position and switch the heater on.
• When the heating element is on the power switch will illuminate.
1. Power switch
2. Thermostat control
3. Handle
4. Finned body
5. Feet
4
5
GB