Berger Move Bedienungsanleitung Seite 17

A. Move System Outside vehicle
B. Supplied 0.5m 'F' to 'F' Cable
C. Move Power Inserter
D. Satellite Receiver
E. Scart Lead OR HDMI Cable (HD or SD compatibility)
F. Cigarette Adapter 12V Power Supply
G. Wall Adaptor 12V Power Supply*
H. 1 x 10m 'F' to 'F' Cable
* Not included in UK variant.
If you require a 12V PSU we recommend a switching PSU rated at minimum of 2 amps.
ATTENTION!
Avoid sharp bends when routing cable
The Berger-MOVE is set to Astra 1 at the factory and the alarm system is deactivated.
In most cases the factory set satellite (Astra 1) is the satellite you want to receive. If this is
the case, you can now continue on page 18 „Satellite search".
The Move supports the following Satellites: Astra 1 - Astra 2 - Astra 3 - Hotbird. Please see
table below to understand how the lights correspond to these satellites.
If you want to change the satellite, proceed as follows: Attention: In the following the pro-
cedure with deactivated alarm system is explained ! When the LED flashes blue, the control
unit is ready to search for the satellite.
Blue Off
1. To enter the Configuration Mode - Press and hold (6 seconds) the power insterer button
until one of the options below appears.
2. Now you can select your desired satellite by briefly pressing the button.
ENGLISH ENGLISH
KEY
POWERING AND OPERATION
Blue Off Blue Off
17 17