Axis Communications M30 Serie Installationsanleitung Seite 18

English
Safety information
Hazard levels
DANGER
Indicates a hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not
avoided, could result in minor or moderate
injury.
NO TICE TICE
NO NO TICE
Indicates a situation which, if not avoided,
could result in damage to property.
Other message levels
Important
Indicates significant information which is
essential for the product to function correctly.
Note
Indicates useful information which helps in
getting the most out of the product.
Safety instructions
NO TICE TICE
NO NO TICE
•
The Axis product shall be used in compliance
with local laws and regulations.
•
Store the Axis product in a dry and
ventilated environment.
•
Avoid exposing the Axis product to shocks
or heavy pressure.
•
Do not install the product on unstable
poles, brackets, surfaces or walls.
•
Use only applicable tools when installing
the Axis product. Using excessive force
with power tools could cause damage to
the product.
•
Do not use chemicals, caustic agents, or
aerosol cleaners.
•
Use a clean cloth dampened with pure
water for cleaning.
•
Use only accessories that comply with the
technical specification of your product.
These can be provided by Axis or a third
party. Axis recommends using Axis power
source equipment compatible with your
product.
•
Use only spare parts provided by or
recommended by Axis.
•
Do not attempt to repair the product
yourself. Contact Axis support or your Axis
reseller for service matters.
Transportation
NO NO TICE NO TICE TICE
•
When transporting the Axis product, use
the original packaging or equivalent to
prevent damage to the product.
Battery
CAUTION
Do not replace the battery yourself. Contact
Axis support if the log message requests a
battery change.
Lithium coin cell 3.0 V batteries contain
1,2-dimethoxyethane; ethylene glycol dimethyl
ether (EGDME), CAS no. 110-71-4.
Dome cover
NO TICE TICE
NO NO TICE
•
Be careful not to scratch, damage or leave
fingerprints on the dome cover because this
could decrease image quality. If possible,
keep the protective plastic on the dome
cover until the installation is complete.
•
Do not clean a dome cover that looks clean
to the eye and never polish the surface.
Excessive cleaning could damage the
surface.
•
For general cleaning of the dome cover it
is recommended to use a non-abrasive,
solvent-free neutral soap or detergent
mixed with pure water and a soft, clean
cloth. Rinse well with pure lukewarm water.
Dry with a soft, clean cloth to prevent water
spotting.
•
Never use harsh detergents, gasoline,
benzene, acetone, or similar chemicals.
•
Avoid cleaning the dome cover in direct
sunlight or at elevated temperatures.
•
Domes for L products come with an
anti-scratch surface. Avoid leaving finger
prints on the dome surface since this might
impair image quality.
Français
Informations sur la sécurité
Niveaux de risques
DANGER
Indique une situation dangereuse qui, si elle
n'est pas évitée, entraînera le décès ou des
blessures graves.