Safety System; Cleaning And Service - Petra electric WK 186 Gebrauchsanweisung

bottom of the handle based on the function of the drainage
holes. This is technically conditional and will not jeopardize
the safety of the appliance.

Safety system

A thermostat protects the boiler from overheating in case of
an accidental operation without water by switching off the
appliance.
The pot must be cooled off prior to filling with water.
If the first thermostat fails due to improper use, an additional
thermostat provides reliable protection.

Cleaning and service

Pull the plug and cool the appliance. Do not immerse the
appliance in water, but wipe with a damp cloth to which a
dishwashing agent has been added and then wipe dry.
Do not use sharp and abrasive cleaning agents.
The pot consists of stainless steel. If rust spots are seen
regardless, these are initially only deposits adhering to the
surface. They should be removed immediately with stainless
steel cleaner.
Decalcification
Calcium deposits result in energy losses and reduce the ser-
vice life of the appliance. It switches off early, if the calcium
coating is too thick. It is then difficult to remove. Decalcify
the pot routinely.
We recommend using durgol
and gentle to materials.
You may obtain it where you bought the appliance; directly
from a select dealer or you can order it directly from petra-
electric .
Disconnect the appliance from the socket and let cool prior
to decalcification. Fill in 1 to 2 cups of durgol
let the appliance stand until the calcium coating is removed
from the bottom. Then fill the appliance with cold water past
the calcium edge and let stand for 15 minutes. Then pour it
out and thoroughly rinse with cold water.
Do not heat the solution during decalcification.
Caution, warranty compensation does not exist for dama-
ges that occur due to non-compliance.
Reasons for malfunctions
• The appliance switches off prior to cooking
The bottom of the pot is exessively calcified, not enough
water has been filled in
• The appliance does not switch off
The lid is not closed
• The appliance cannot be switched on
The appliance is not sufficiently cooled after an operation
without or with an insufficient amount of water.
If the malfunction cannot be resolved, the appliance must be
repaired.
®
express. It is very effective
® express and
9