Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Heizluefter_477091.book Seite 19 Mittwoch, 12. Juni 2013 2:05 14
For your safety
General safety instructions
• To operate this device safely, the user
must have read and understood these
instructions for use before using the
device for the first time.
• Observe all safety instructions! Failure to
do so may cause harm to you and others.
• Retain all instructions for use, and safety
instructions for future reference.
• If you sell or pass the device on, you must
also hand over these operating instruc-
tions.
• The device must only be used when it
functions properly. If the product or part
of the product is defective, it must be
taken out of operation and disposed of
correctly.
• Never use the device in a room where
there is a danger of explosion or in the
vicinity of flammable liquids or gases.
• Always ensure that a device which has
been switched off cannot be restarted
unintentionally.
• Do not use devices with an on/off switch
that does not function correctly.
• Keep children away from the device!
Keep the device out of the way of children
and other unauthorised persons.
• Do not overload the device. Do not use
the device for purposes for which it is not
intended.
• Exercise caution and only work when in
good condition: If you are tired, ill, if you
have ingested alcohol, medication or ille-
gal drugs, do not use the device, as you
are not in a condition to use it safely.
• This product is not intended to be used
by persons (including children) or who are
limited in their physical, sensory or men-
tal capacities or who lack experience
and/or knowledge of the product unless
they are supervised, or have been
instructed on how to use the product, by
a person responsible for their safety.
• Ensure that children are not able to play
with the device.
• Always comply with all applicable
domestic and international safety, health,
and working regulations.
Electrical safety
• The device may only be connected to a
socket that is correctly installed and
grounded.
• The fuse must be a residual current cir-
cuit-breaker with a measured residual
current of no more than 30 mA.
• Make sure that the power supply corre-
sponds with the connection specifica-
tions of the device before it is connected.
• The tool may only be used within the
specified limitations for voltage and
power (see type plate).
• Do not touch the mains plug with wet
hands! Always pull out the mains plug at
the plug and not by the cable.
• Do not bend, crush, pull or drive over the
power cable, protect from sharp edges,
oil and heat.
• Do not lift the device using the cable or
use the cable for purposes other than
intended.
• Check the plug and cable before each
use.
• If the power cable is damaged immedi-
ately disconnect the plug. Never use the
device if the power cable is damaged.
• If the device is not in use make sure the
plug is pulled out.
• Make sure that the device is switched off
before plugging in the mains cable.
• Make sure that the device is switched off
before unplugging it.
• Disconnect the power supply before
transporting the device.
Device-specific safety instructions
• The surroundings must be free of highly-
flammable or explosive materials.
• The device must be standing clear all
around on an even, horizontal surface.
• The distance towards the front between
the front grate and objects must be at
least 65 cm. Towards the back, the
device must be clear for air supply.
• With the pivoting model, the pivot area
must be kept clear.
• The device may not be fastened to the
wall.
GB
19
Werbung
Kapitel
