Operation; Light Sensor - be cool BC52LR2101 Bedienungsanleitung

You can set all functions directly on the unit.
Depending on the function set, the indicator lights on the control panel light up.
SWITCH ON THE UNIT
1. Connect the unit to the earthed socket.
2. Press the
3. When the unit is switched on, it starts in smart mode.
4. The - indicator lights up.
5. Press the
6. In standby mode, the
Never switch off the air purifier by pulling the plug directly from the mains. To switch off,
always press the on/off button and wait a few minutes before disconnecting the unit from the
mains. This allows the unit to go through a cycle of checks to verify its functionality.
SET FUNCTIONS
Smart mode
Optimal for everyday use, the unit itself controls how strongly the air is cleaned.
1. Press the
2. To exit smart mode, press the
Air quality
indicator Light
PM2.5 value
Fan stage

Light sensor

The unit has a light sensor that adjusts the backlight and air quality indicator to the ambient
brightness when the unit is in smart mode.
When it is dark, the display illumination and the air quality indicator are dimmed down to a
minimum.
It is recommended to use the unit in Smart mode. In Smart mode, the unit works most
efficiently as it regulates the fan speed automatically based on the level of particulate matter

OPERATION

- button to switch on the unit.
- button again to switch to standby mode.
- indicator lights up slightly.
NOTE
- button until the "Smart" indicator on the control element lights up.
Fan speed listing based on PM2.5 value
Blue
0-50
Low
NOTE
in the room.
Seite 25 von 32
- button again.
Green
50-100 100-150
Medium
Yellow Red
150+
High Turbo