Playing Photo Contents; Using The Tools Menu; Appendix; Troubleshooting - Samsung BD-F5500 Bedienungsanleitung

To change the play list, press the @ or
5.
RETURN button to return to the Music
List. Repeat Steps 2, 3, and 4.
6. To cancel the play list and return to the
Home screen, press the RETURN or
EXIT button.
✎
NOTES
` You can create a playlist with up to 99 tracks
on Audio CDs (CD-DA).
` If you remove all the tracks from a play list and
then press the v button, the player lists and
plays all the tracks on the disc.

Playing Photo Contents

You can control the playback of photo content
located on a Blu-ray disc, DVD, CD, USB
device, or your computer.

Using the Tools Menu

During playback, press the TOOLS button.
Start Slide Show/
Select to start or stop the slide
Stop Slide Show show.
Slide Show Speed Select to set a slide show's speed.
Background Select to listen to music while
Music viewing a slide show.
Select to enlarge the current
Zoom
picture. (Enlarge up to 4 times)
Select to rotate the picture. (This
Rotate will rotate the picture either
clockwise or counter clockwise.)
Information Shows the picture information.
✎
NOTES
` Depending on the disc or storage device, the
Tools menu may differ.
` To enable the background music function, the
photo file must be in the same storage media
as the music file.
However, the sound quality can be affected
by the bit rate of the MP3 file, the size of the
photo, and the encoding method.
` You can't enlarge the subtitle and PG graphic
in the full screen mode.

Appendix

Before requesting service, please try the following solutions.
PROBLEM
• Check the batteries in the remote control. They may need replacing.
No operation can be
• Operate the remote control at a distance of no more than 6.1m from the
performed with the remote
control.
player.
• Remove batteries and hold down one or more buttons for several minutes
to drain the microprocessor inside the remote control to reset it. Reinstall
batteries and try to operate the remote control again.
• Ensure that the disc is installed with the label side facing up.
Disc does not play.
• Check the region number of the Blu-ray Disc/DVD.
• Ensure that the disc has disc menus.
Disc Menu does not appear.
• This message appears when an invalid button is pressed.
The prohibition message
• The Blu-ray Disc/DVD's software doesn't support the feature (e.g., angles).
appears on the screen.
• You've requested a title or chapter number or search time that is out of range.
• Some of the functions selected in the Setup Menu may not work properly if
Play mode differs from the
Setup Menu selection. the disc is not encoded with the corresponding function.
• The Screen Ratio is fixed on your Blu-ray Disc/DVD.
The screen ratio cannot be
• This is not a problem with the player.
changed.
• Make sure you have selected the correct Digital Output in the Audio Options
No audio.
Menu.

Troubleshooting

SOLUTION
19