Werbung
3
5
Inset
A
Inset
B
Figure
10
7
8
Figure
11
12-""--
13_
14...-.. _
16
inset C
1.
Outer side shield
2.
Nut "A"
3.
Nut"B"
4.
Drive control bar
5.
Handle
6.
Throttle control
10. Transport position
11. Shallowest
tilling
12. Shallow tilling
13. Deep tilling
14. Deepest tilling
15. Depth stake
(_)
Reverse
a.
Release the drive control bar (fig. 10).
b. Move throttle control (fig. 10) to "SLOW" speed
c.
Place shift lever indicator _fig. 11 -inset A) in the "R"
(reverse)
posffion.
d.
Do not stand directly behind tiller.
e,
Hold the ddve control bar against the handle (fig. 10) to
start tiller movement.
Tines will not turn.
_ll
WARNING!
Don't back yourself into a solid obstruction such as a tree,
fence, etc.
Stopping
tines and engine
a.
Tiller movement and tines will stop when drive control
bar (fig. 10) is released.
b.
Move shift leverindicator
(fig. 11 -inset A)to"N" (Neutral)
position.
c.
To stop engine, move throttle control (fig. 10) to "STOP"
position.
Turning
a. Re_ease the drive controlbar (fig. 10).
b. Move throttle control (fig. 10) to "SLOW" position.
c.
Placeshiftleverindicator(fig,11
-insetA) in"F"(forward)
position.
Tines will not turn.
d.
Lift handle to raise tines out of the ground (fig. 10)
e. Swing the handle in the opposite direction you wish to
turn, being careful to keep feet and legs away from the
tines.
When you have completed
your turn-around,
lower the
handle. Place shift lever indicator in "T" (tilling) position and
move throttle control to desired speed. To begin tilling, hold
drive control bar against the handle.
Outer side shields
The back of the outer side shields (fig, 1O)are slotted so that
they can be raised for deep tilling and lowered for shallow
tiltingto protect small plants from being buried. Loosen nut
'A" in slot and nut "B". Move shield to desired position (both
sides).
Retighten nuts.
Transporting
e.
Lower the depth stake to its lowest position and insert
the depth stake pin in the t_amost hole.
b.
Place shift lever indicator (fig. 11 inset A) in "F" (foward)
position for transporting.
c.
Hold the ddve control bar against the handle (fig. 10) to
start tiller movement.
Tines will not turn.
d.
Move throttle control (fig. 10) to desired speed.
7.
Shift lever indicator
8.
Depth stake
9.
Depth Stake pin
16, "Release" position
17. "Lock" position
30
Werbung
