User Interface Of The Software - Hifonics Medusa Serie Benutzerhandbuch

10
1
11
12
Here you can make countless settings and adapt them to your sound system, which can be heard immediately in real time via the DSP
device. As soon as you are finished configuring a setting, it can be transferred to one memory locations in the DSP device. You can store
up to 10 different settings and select the remote control at any time during operation. The following section explains the various functions
of the M-CONTROL 2 user interface.
1
LINK TO DEVICE: Connects the PC via USB to the DSP device.
Channel Setting": Opens a dialog box where you can select the configurations for your desired
2
sound system.
There you can freely define the assignment of the inputs (INPUT) and outputs (OUTPUT) per
channel on the DSP device.
In „SPEAKER TYPE", you can select the desired speaker for each channel. This means that
the appropriate parameters are already preset at the respective channel, and you only have to
perform the fine adjustment.
„MIX" must be selected when using the high level inputs on the DSP device. The audio signal
is summed.
Under „2CH", „4CH" or „6CH" (input assignment), you can select an already preset sound
system variant, which you can set beforehand. All you have to do is make the fine adjustment.
3
Open: Opens a previously saved setting on the PC.
Save: Saves a setting in a file on the PC with the current filename used. If no file name has been selected before, you can
4
specify any filename in the following dialog.
5 SaveAs: Saves the setting under a different filename, which you can specify in the following dialog.
6 Factory Setting: Resets all settings to the factory default.
24
FUNCTIONAL INSTRUCTIONS

USER INTERFACE OF THE SOFTWARE

3 4 5
8
9
6 2
7
13
14
15
17
16