Philips HF3485 Wake-up Light Bedienungsanleitung Seite 11

setting the sunrise simulation time
The sunrise simulation time is the time in which the light intensity of the lamp gradually increases to
the set level before the alarm sound is played. The default sunrise simulation time is 30 minutes,
because this is the optimum time for your body to prepare for waking up. As the sensitivity to light
differs from person to person, it is possible to adjust the sunrise simulation to your own preference.
You can reduce the sunrise simulation time to 20 or 25 minutes or increase it to 40 minutes.
1 Simultanuously press and hold the light intensity increase and decrease buttons for
3 seconds (Fig. 24).
, The sunrise simulation symbol and the default sunrise simulation time of 30 minutes appears
on the display. (Fig. 25)
2 Press the menu - or + button to increase or decrease the sunrise simulation time. (Fig. 9)
Press the SELECT button to conirm (Fig. 10).
3
snoozing
1 Tap on the surface of the Wake-Up light with the inside of your hand to snooze the appliance
(some force needs to be applied to prevent accidental snoozing) (Fig. 26).
The lamp continues to be on at the selected intensity level, but the alarm sound stops. After
,
9 minutes, the alarm sound is automatically played again.
Note: The 9-minute snooze time is ixed. This time cannot be adjusted.
switching the alarm function off and on
To switch off the alarm function when the alarm goes off, push down the control lever to the
1
bottom position (Fig. 27).
Note: The lamp stays on to light your room. You can switch off the lamp by pressing the lamp on/
off button.
Note: If you forget to switch off the alarm, the alarm (sound and/or light) automatically switches off after
90 minutes.
2 If you want the alarm to go off at one of the set alarm times the next day, set the control
lever to alarm 1 or alarm 2 again.
alarm demonstration
If you want to get a quick demonstration (60 seconds) of the gradually increasing light intensity and
sound level, activate the test function of the appliance.
1 Simultanuously press and hold the menu - or + buttons until the word TEST appears on the
display (Fig. 28).
2 Simultanuously press the menu - or + buttons again to stop the demonstration.
Note: The appliance continues to run the alarm demonstration until you press the menu + and - button
again. The test automatically stops after 9 hours.
using the radio/playing music from a usB stick
switching on the radio
1 To switch on the radio, press the radio on/off button (Fig. 29).
, The radio starts to play.
Note: The radio function has 3 preset stations. To select one of the preset stations, press the SELECT
button below the display.
2 To select the desired radio frequency, press the menu - or + button. (Fig. 30)
EnglisH
11