Troubleshooting - Vaporella FOREVER 630 Bedienungsanleitung

11. TROUBLESHOOTING

PROBLEM
If water comes out from
the Iron soleplate in-
stead of steam.
Steam does not come
out from the Iron sole-
plate
Little steam comes from
the Iron soleplate.
Some water drops are
present on the fabric.
Presence of water un-
der the appliance.
If problems persist or are not listed above, please contact a Polti Authorised Service Centre
(www.polti.com for the updated list) or contact Customer Services.
Downloaded from www.Manualslib.com
CAUSE
The pressure values have
not been reached
The temperature knob on
the iron is set at the mini-
mum value.
First steam release.
ON-OFF button and boi-
ler button off.
Water tank is empty.
The steam regulation
knob is set at the mini-
mum value.
The steam is dry, so is ba-
rely visible, but is present
and effective.
The cover used on the
Ironing board is wet since
it cannot withstand the
power of the steam sta-
tion.
Boiler cap not screwed
on properly.
Seal of boiler cap dama-
ged.
manuals search engine
SOLUTION
Check that the ready steam lamp is
OFF indicating that the Vaporella
has reached the right pressure
Wait until the required temperature
and pressure are reached as shown
by the indicator lights.
Adjust the temperature knob on
the iron to the medium/maximum
vaue.
Release onto a cloth until steam
comes out from the holes on the
solepate.
Make sure that the appliance is
powered and that the power ON-
OFF and boiler button are on
Fill the water tank.
Increase the steam flow by adju-
sting the steam regulation knob to
the medium/maximum value.
This is normal especially in particu-
lar environmental conditions.
Check that the Ironing board is sui-
table (ironing board with grid that
prevents condensation).
Unscrew and rescrew the boiler
cap (Chapter 9).
Replace the damaged seal (Chap-
ter 9).
| 25 |