Electrical Wiring; Technical Specifications - Polar CB507 Bedienungsanleitung

UK
Fault
The appliance turns
on, but the
temperature is too
high/low
The appliance is
leaking water
The appliance is
unusually loud

Electrical Wiring

POLAR appliances are supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as
standard.
The plug is to be connected to a suitable mains socket.
POLAR appliances are wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
All POLAR appliances must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.

Technical Specifications

Model Voltage
G619 230V
G211 50Hz
CB507 230V
DP288 50Hz
CB509 230V
DP289 50Hz
CG582 230V
50Hz
5
Downloaded from www.Manualslib.com
Probable Cause
Appliance is overloaded
The appliance is not properly
levelled
The discharge outlet is blocked
Movement of water to the drain
is obstructed
The water container is
damaged
The frame has become loose
The appliance has not been
installed in a level or stable
position
Temperature
Power Current
180W 1.2A 2°C to 12°C
180W 1.2A 2°C to 12°C
250W 1.5A 2°C to 12°C
210W 1.35A 2°C to 12°C
manuals search engine
Reduce the amount of food stored in the appliance
Adjust the screw feet to level the appliance (if applicable)
Clear the discharge outlet
Clear the floor of the appliance (if applicable)
Call POLAR agent or qualified Technician
Check and tighten all nuts and screws
Check installation position and change if necessary
Capacity
Refrigerant
Range (litres)
70
86
235 R600a 100g
100
Action
Dimensions
H x W x D (mm)
R600a 40g 885 x 428 x 386
R600a 40g 980 x 428 x 429
1695 x 515 x 485
R600a 50g 1100 x 565 x 565
Weight
(kg)
32.5
36,5
76.4
50