Pack Contents; Installation; Operation - Polar GL193 Bedienungsanleitung

Telephone Helpline: 0845 146 2887 (United Kingdom)

Pack Contents

The following is included:
• Ice Maker
• Ice scoop
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied
fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.
Note: Only use the hoses supplied with the appliance. Other hoses are not suitable and
should not be used.

Installation

Note: If the appliance has not been stored or moved in an upright position, let it stand
upright for approximately 12 hours before operation. If in doubt allow the appliance to
stand.
Remove the appliance from the packaging and remove the protective film from all surfaces.
1.
When positioning the ice maker, maintain a distance of 20cm
2.
(7 inches) between the appliance and walls or other objects for
ventilation. Increase this distance if the obstacle is a heat source.
If necessary, adjust the screw legs of the ice maker to make it level.
3.
The efficiency of the ice maker can be reduced if the appliance is
unevenly located.
Connect one end of the corrugated outlet hose to the water outlet
4.
on the rear of the ice maker.
Attach the other end of the hose to a plumbed-in stand waste pipe
5.
or container suitable for collecting waste water.
Place the sealing washers on the water inlet at the back of the ice
6.
maker and attach one end of the inlet hose.
Connect the other end of the inlet hose to the water supply.
7.
Note: Ensure the end of the drainage pipe is situated lower than the Water Outlet valve
for efficient drainage.

Operation

Note: Before using for the first time (or after a period of inactivity), clean the water tank,
ice basket and ice basket shelf. Use the first two ice making cycles to flush out the
system. Discard the water and ice created from these initial cycles.
Press the Power switch (located on the front of the appliance) to the On position [I]. The initial cycle
1.
will take approximately 30 minutes, with subsequent cycles taking approximately 25 minutes.
When the cubes reach the ice sensor ice production stops. Production resumes once ice has been
2.
removed from the bin.
Press the Power switch to the Off position [O] at any time to halt the ice making process.
3.
Downloaded from www.Manualslib.com manuals search engine
• Inlet/Outlet hoses
• Instruction manual
UK
Water
outlet
Water
inlet
2