Inhaltsverzeichnis
Werbung
VH226-EN-QSG.fm Page 4 Friday, August 22, 2008 5:26 PM
Connecting the cables
1.
Connect the cables according to the following instructions:
(VH226H)
Earphone jack
Audio-in
•
To connect the audio cable: connect one end of the audio cable to the monitor's
Audio-in port, the other end to the computer's audio-out port.
•
To connect the power cord: connect one end of the power cord securely to the
monitor's AC input port, the other end to a power outlet.
•
To connect the VGA/DVI/HDMI cable:
a. Plug the VGA/DVI/HDMI connector to the LCD monitor's VGA/DVI/HDMI port.
b. Connect the other end of the VGA/DVI/HDMI cable to your computer's VGA/DVI/HDMI port.
c. Tighten the two screws to secure the VGA/DVI connector.
•
To use earphones: connect the end with plug type to the monitor's earphone
jack.
•
When these cables are connected, you can choose the desired signal from the Input Select item
in the OSD menu.
•
The HDMI cable is purchased separately.
2.
Gather all the cables with the cable management slot.
Adjusting the monitor
•
For optimal viewing, we recommend that you look at the full face of the monitor,
then adjust the monitor to the angle that is most comfortable for you.
•
Hold the stand to prevent the monitor from falling when you change its angle.
•
You can adjust the monitor's angle from -5° to 20°.
4
(VH226S)
HDMI
VGA
HDMI
VGA
-5° to 20°
Quick Start Guide
Audio-in
VGA
Cable
management slot
Werbung
Inhaltsverzeichnis
