Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Features
Front Panel
5 6 7 8 9
1
1.
Power Button: Press this button to turn the unit on or off.
2.
Display: This screen indicates the unit's current operation.
3.
Tuning Buttons: Press one of these buttons to increase or decrease the frequency one step at
a time. Press and hold the button for more than 1 second to jump to the previous or next
station with clear reception.
4.
Number Buttons (1–10/10+): Press buttons 1-10/10+ on the unit or the remote control to recall a
saved preset from 1-10. To recall presets higher than 10, press the 10/10+ button on the unit or
remote control followed by the additional number button to get to the desired preset (e.g. to get to
preset 12, select 10/10+ followed by 2). To get to preset 20, press the 10/10+ button twice.
5.
Memory Button: To save a preset, press the Memory button, then press a Number button (1–
10/10+) to select location, and press the Memory button again to save the current station to
that preset number.
6.
Auto Button: Press this button to select Auto or Manual tuning for AM and FM stations. Press
once to set to Auto and the unit will search for the next clear station when using the Tuning
Up/Down buttons. Press to set to Manual and you can manually search for stations with the
Tuning Up/Down buttons.
7.
ST/MO: Press this button to alternate between Stereo mode and Mono mode
Stereo: FM stereo broadcasts are received in stereo and the "ST." indicator lights on the display.
Mono: To compensate for weak FM stereo reception, select this mode. Reception will now be
monaural, reducing unwanted noise.
8.
Band: Press this button switches between FM and AM radio.
9.
Display Button: When in FM mode, press this button to show different operation information
on the screen.
Rear Panel
3
1.
AC In: Use the included power cable to connect this input to a power outlet.
2.
Voltage Selector: The voltage selector setting should only be changed when necessary (e.g.,
when traveling to a country or region with a different voltage). Selecting an improper voltage
setting can damage the unit. To change its setting, only remove *one* screw of the cover and
slide it aside to expose the selector.
3.
FM Antenna Terminal: Connect the included FM antenna to this terminal.
4.
AM Antenna Terminals: Connect the included AM loop antenna to this terminal. See
Connection Diagram
5.
Audio Outputs (unbalanced RCA): These outputs send the audio signals from the radio
station. Use RCA cables to connect these outputs to external speakers, sound system, etc. See
Connection Diagram
6.
Audio Outputs (balanced XLR): These outputs send the audio signals from the radio station.
Use XLR cables to connect these outputs to external speakers, sound system, etc. See
Connection Diagram
7.
Firmware Update: This USB port is used to upgrade the unit's firmware. The "Update/Normal"
switch is used to set the mode for the USB connection for the firmware upgrade. For normal
operation, this switch should be left in the Normal position.
4
4
6
5
for more information.
for more information.
for more information.
2
3
7
4
1
2
Werbung
Inhaltsverzeichnis
