Nebula BOOST Anweisunghandbuch Seite 4

NOTE: - If you need to stop the unit for any reason press and hold the start/stop button or
switch off from the plug.
All of the components that come with the unit must be used every time.
1. The unit consists of 4 parts: the green base, the removable inner canister, the green silicone cap, and the
green lid.
2. The unit uses a smart computer to finish the decarb process and has a range in its cycle. It should never run
for more than 2.5 hours - if you notice your unit is running longer than it should carry out a manual stop by
holding down the start/stop button or unplug the unit - then contact us: - sales@nebulaboost.com. If
anything seems amiss it is always best to contact us right away so we can help!
3. The Boost is for indoor use only and needs to be used at room temperature - not in a garage or a basement!
Doing so can cause the unit to run outside of its normal cycle which may result in damage. Misuse of the
unit is not covered under the warranty.
4. Your unit should always cool between every cycle - it needs to be left to cool at least 25-30 minutes after you
have used it. It should always be cool to the touch when starting.
5. Once you start the cycle just let it run! It is important that the unit not be opened while the cycle is still run-
ning – this is for safety and to complete the process successfully!
6. Some condensation is completely normal when decarbing and afterwards- the herbs have water content
that is released when the herb is heated.
7. You can switch the temperature from °F to °C. Switch on at the plug. Press the Start/Stop once to show the
time. Press and hold Temp- & Temp+ together for 3 seconds. The temperature will now show in °C. Reverse
the process to change back to °F. PLEASE NOTE:- Device will revert to °F when you unplug and restart
Nebula Boost Instruction Manual Page | 04