Instruction Manual; Quick Start - Nebula BOOST Anweisunghandbuch

Instruction
E
Manual
N
For Video Assembly please visit
www.nebulaboost.com

QUICK START

1. Get together all the components -- the green base, the removable inner canister, the green silicone cap, and
the green lid.
2. Plug in the base and load the canister up with your plant material. The material should be packed loose with
room on the top.
3. Put the inner canister back into the green base, place the green silicone cap firmly onto the inner cannister
and the turn the lid clockwise until the lid clicks into place. The lid will not move any further once it has been
secured.
Ensure your herb is completely dry otherwise the lid will open during
4. Press the Start/Stop centre button. The display will change from "-- --" to "01:30" This is the default time for the
process. Now you can set the temperature using the "temp+ or temp- " and time using the "time+ or time- ".
You can set the exact temperature and time you require. We recommend setting the time for 1hr:30mins &
temperature at 110°C (230°F) for the perfect decarboxylation process.
5. Now press the Start/Stop button to start the decarboxylation process. You will notice the middle of the time
will start to blink; this will show the device is working. The cycle should last a total of around two hours includ-
ing cool down. While the Nebula Boost is in operation do not touch or open the device.
6. When the process has completed you will see the "-- --" on the front of the device. Carefully open the unit
using heat proof gloves and open the silicone lid (do not touch with bare hands this could be very hot) Using
gloves or tongs carefully take our your decarbed material. When the process is complete it will look darker like
below right.
Before
Nebula Boost Instruction Manual
decarb.
After
Page | 03