Aurora AU-A1ZBSCD Kurzanleitung

MODEL
AU-A1ZBSCD
INPUT VOLTAGE (V) 12-24V DC
INPUT CURRENT 8A @ 24V DC / 12V DC
OUTPUT VOLTAGE 12-24V DC
NUMBER OF OUTPUTS 2 x single colour LED strips
96W @ 24V DC per output
MAX LOAD
48W @ 12V DC per output
AMBIENT TEMPERATURE LIMITS -20°C~+50°C
IP RATING IP20 (Indoor Use Only)
NUMBER OF OPERATING CYCLES 1E4
CIRCUIT DISCONNECTION Electronic disconnection
PROTOCOL ZigBee 3.0
Twin and Earth 0.75~1.5 mm
CONDUCTOR TYPE & SIZE
Flat x2C+E 0.75~2.5 mm
FREQUENCY BAND 2.405 - 2.483GHz
MAX OUTPUT RF POWER 12.66dBm
INSULATING MATERIALS Polycarbonate
GLOW-WIRE TEMPERATURE 850
°C
PROTECTIVE DEVICE 100°C Recoverable temp control
• There are no restrictions of use.
• Installation must be carried out in accordance with the latest edition of the
Wiring Rules by a qualified electrician.
• Earth terminal is for Termination only.
• Hereby, Aurora Limited declares that the radio equipment type
AU-A1ZBSCD is in compliance with Directive 2014/53/EU. The full text
of the EU declaration of conformity is available at the following internet
address: www.auroralighting.com/ProductDetail/AU-A1ZBSCD
USING THE APP TO CONNECT THE LED STRIP
CONTROLLER TO THE HUB
1. Download the AOne App from the App Store.
2. Follow instructions on the App to send the hub into pairing mode and pair
your devices (further details below).
3. Put the controller into pairing mode by:
a) Connecting the controller to a power outlet and turning on the power, or,
b) Pressing the pairing button for 3 seconds, or,
c) Powering the controller off for a minimum of 2 seconds and back on
again 6 times. The on periods must be between 0.5 - 1.5 seconds.
The LED Strip will flash twice to indicate it has entered pairing mode.
The LED Strip will flash a third time to indicate that it has successfully
paired with the hub.
The controller can then be controlled using the AOne App.
1
IMPORTANT INFORMATION:
• The strip controller works on 12V/24V DC, it cannot be
used with 220-240V AC directly.
• Remove any existing dimmers from the circuit.
• The strip controller fits between the non-dimmable LED
driver and LED strip (LED driver NOT included).
• We recommend LED strip below 10W per metre can run a
maximum of 10m and for LED strip above 10W per metre
a maximum of 5m. This is based on an incoming cable
between driver and start of LED strip of 5m.
• For further details please check specific LED strip data.
2 (UK)
2 (Australia)
4
6
2
5
7
Pairing
button
www.auroralighting.com
3
220-240V
Mains Supply
V- V+
V- V+
LED Strip
12-24V DC
8
Download / control through the
Document Version: AU-A1ZBSCD_V3_18
+ + - -
+ + - -
+ - + -
12-24V DC
AOne App